Home > Accessories > Rope Grabs >

Rope Grab for 5/16″ and 3/8″ Galvanized or Stainless Steel Wire Rope

5/16" and 3/8" Wire Rope Grab | US-5038


 

3/8" Wire Rope Grab | US-5038E
Our Price: $249.50



Availability: Usually Ships in 24 to 72 Hours
Product Code: US-5038
Qty:

Description
 
The Model # US-5038 is a small wire grabbing device that follow a worker’s movement up and down a vertical lifeline. If a fall occurs, the cable grab locks on the cable and reduces that possibility of serious injury. An energy absorbing lanyard is used for connection between the cable grab and worker’s harness to reduce the forces generated during a fall and to insure compliance with OSHA’s maximum force requirements.

BEFORE USE

  • Inspect the rope grab for any damage, dirt, oil, grit, paint, etc. Refer to “Cleaning” section on page.
  • Make sure the lifeline is the proper type and size. (3/8″ diameter Stainless steel or galvanized 7×19 aircraft cable (non-lubed) with a minimum tensile strength of 8,000 Ibs.)
  • Tie off the bottom end of the lifeline vertically below the anchorage point to eliminate excess slack.
  • MUST be used with a Shock-Absorbing lanyard or on a cable with an integrated shock absorber to limit arrest force
  • MEETS OSHA & ANSI Z359.1

Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

Accessories > Rope Grabs
Accessories
Manufacturers > Ultra-Safe Fall Protection